looking for some advice on a 555 Roller cam
#1
Junior Member
SHOW GUEST
Thread Starter
Join Date: Dec 2003
Location: New Hampshire
Posts: 8
looking for some advice on a 555 Roller cam
Hi I am looking for some advice on a roller cam for a 2530 pound (w/driver) car. The comb. is as follows--- 555 BBC,tube chassis,33-17 tires,T-400 w/brake,Coan 9 inch w/5200 stall,4.10 gear,single dom. carb.,Dart 355 cnc heads-then hand ported,ported super victor intake,15-1 comp,2 1/4 into 4 inch collectors,I may spray with an occasional 100-150 shot( to poss. run TS ) -I would like to spin it to 8000. I am more concerned with the perf. on the motor than building a Nitrous motor.
Thanks very much for your time.
Thanks very much for your time.
#3
Senior Member
MASTER BUILDER
Join Date: Dec 2003
Posts: 185
scuncio, Call PBM Preformance Products 1-800-641-7920 They are Erson Cams and will sell you anything you want alot less that R&M will :lol:
I ordered a cam on Monday that they didn't have in stock and it was on my door step on Friday the same week!!!!
I ordered a cam on Monday that they didn't have in stock and it was on my door step on Friday the same week!!!!