Originally Posted by doorracer
Originally Posted by cncmotorsports
Originally Posted by jreiley
Don't the 12,15 and 18 degree heads use the same intake and exhaust.
12, 15 and 18 degree take the same intake
700 HP is easy with either 23 degree or 18 degree
I'm with Zip on this. 700hp with 23° heads is not "easy". If it were that easy for you guys I would be seeing a lot of CNCmotorsports sbc motors out there, because you guys could sell them cheap, and hearing a lot of buzz about them. Or at the very least you would be selling quite a few of those 23° heads you are using to do it. Not saying it can't be done just saying
it ain't easy.
Curtis
If your end goal is 700 horsepower and you will never want to get more power, then a 23 degree will be expensive, if a chance exit that you will want more than that in the future, then 15 degree will be the ticket. Initial cost could be higher but, the power potential is far greater. Post your question on this forum
http://www.yellowbullet.com/forum/forumdisplay.php?f=14 also if you search the post you will find a wealth of information.
Yedi