Hate to come in late on this thread,,, I run an aluminum roller bearing block, and I used to adjust cold with the EOIC method l...but I find that each lobe seems to have a different low spot. And I seem to have to rotate each lobe till I find the lowest spot, maybe I`m just being picky but, the cam is not ground true, or the roller bearings are out of wack,,either way I have to set each one separate,,has anyone come across this ? some are out 2-3 thou. Is this a common thing ? and I go cold .007, the aluminum block with heads really moves especially 10.2 tall deck, even Oil pressure drops lots from cold to hot. so I run a big external oil pump too...everything expands lots more than steel................anyone lookin for a 10.2 talldeck alum.wet block ??? lol