Originally Posted by camarotale
I appreciate the feed back and feel good about the things im hearing. I am putting the tranny back in this weekend, then I will put jacks under at ride height, and pull a slick and give a accurate ic and try to attach a photo, be back to you in a couple days, thanks
Along with the picture, if you give us some measurements we can come close to calculating your IC, too.
With the car on the ground, measure from the ground (if you do this up on jack stands be sure that the car is level and to give/or subtract the distance from the ground up to the bottom of the slick) up to the center of the bottom bolt of the 4-link bar at the rear end housing, then from the ground up to the center of the rear end housing, and finally from the ground up to the center of the bolt for the top 4-link bar at the rear end housing. If you can get a measurement of how far forward from the centerline of the rear end housing that the top hole is that would be good.
Next measure at the front brackets, and give the measurement from the ground up to the center of the bolt for the bottom 4-link bar and then from the ground up to the center of the bolt of the top 4-link bars. We then will need the length of the top and bottom 4-link bars from the center of the bolt to the center of the bolt.
The final measurement would be the distance from the center of one hole to the center of the next hole in your front 4-link brackets.
Thanks,
Bill