Originally Posted by jpcomeaux
I agree too much is made in China, but that isn't the point here.
I disagree about the knockoff engine blocks from PBM. Currently I have 2 SBC's that I am using with these aftermarket blocks from PBM. My engine builder got them for me in a 4.155" bore. These were ready to assembled. Everything speced out perfect! These have proven to be a value beyond my expectations. I would be more interested in hearing the findings of an independent test. Even more surprising is the web page link listed isn't functioning? To anyone out there, I would use these blocks over again, and recommend them to anyone interested. I look forward to your comments.
:x :x
My new website is under constuction as the gentlmen that designed mine is going through a devorce at this time a is no longer doing websites at this time.
What machines did you verify lifter bore and cylinder bore and cam tunnel locations with and son't tell me a vernier and what did the block brinell test at??
By the end of the week I should have some good photos and some reports on demensions.
Believe me those blocks are sent to Florida and a shop their is engraving PBM on the caps and blocks adding a stud kit line hone and finished machined.
The one we have the oil galley hole is to low int the bore and is not even square with the main line and you can see that by eye!!
I am sure you sonic tested right????????????